Shown with system 100+ 150g flat back sinker - available separately

To Make this Rig
For the rig body, you will need;
1 x Link Clip
6 x Mini-Crimps
6 x 3m Beads
3 x 45lb Snood swivels
3 x SRT Springs
2 x Bent Rig Clips
1 x ABC Link Clip
1 x approx. 1550mm length 60lb main line (for 1250mm body)

You will also need;
3 x350mm snood


The Rig Body

1. Clip two of the swivels onto the bent rig clips.

2. Attach the bait clip to the ABC Link Clip, tie the clip onto your line and thread on the rest of the components in this order.

3. Tie on the top Link Clip, ensuring the main line is at 1250mm.

4. Hang the rig from a peg, attach a sinker and locate the aBC clip in the slider.

5. Clip a snood onto the lower swivel and put the hook in the bait clip.

6. Hold the sinker down firmly and, with a pair of pliers, push the crimp that is under the spring assembly up the main line until the spring is 2/3 compressed and secure it.

7. Release the hook from the bait clip, to decompress the spring, let the bead and crimp above the swivel rest on it and scure the crimp.

8. Clip on the moddle snood, locate the lower snood in the ABC clip and put the middle snood hook in the lower bent rig clip and repeat sections 6 & 7.

9. Repeat section 8 for the upper snood, ensuring both lower snoods are located in their bait clips.