Shown with system 100+ 150g flat back sinker - available separately

To Make this Rig
For the rig body, you will need;
1 x Link Clips
5 x Mini-Crimps
6 x 3mm Beads
2 x SRT Spring
1 x 200mm Boom
1 x 150mm Boom
1 x ABC Long Clip
1 x ABC Link Clip
1 x approx. 1130mm length 60lb main line (for 1200mm body)

You will also need:
1 x 500mm snood
1 x 350mm snood


The Rig Body

1. Attach the long bait clip to the ABC LInk Clip, tie the clip onto your line and thread on the rest of the components in this order.

2. Tie on the top Link Clip, ensuring the main line is at 830mm.

3. Hang the rig from a peg and attach a sinker and locate thte ABC clip in the slider..

4. Allowing the bottom two 3mm beads and short bait clip to rest on the knot, secure the crimp 5mm above the top bead.

5. Locate the ABC clips in the slider.

6. Clip the lower 350mm snood onto the lower boom and locate the hook in the lower bait clip.

7. Hold the sinker down firmly and with apair of pliers, push the crimp that is under the lower spring assembly up the main line until the spring is fully compressed and secure it.

8. Let go of the sinker whilst ensuring the hool remains in the bait clip, which will allow the spring to slightly decompress. allow the top bead to rest on the boom and without compressing the spring further, secure the top crimp immediately above the bead. (This will ensure enough pressure on the boom to hold it out.)

9. Repeat steps 7 and 8 for the upper 500mm snood, using the upper bait clip.